In this post I’ll show you how a 12 bit DAC model MCP4725 can be connected and controlled by Arduino or a compatible board. Similar design based on Raspberry Pi platform can be found at this link . Wire.h and ...

Vacuum fluorescent display can be a good alternative to a Liquid-crystal displays in some applications. They have a number of advantages over LCD like extended temperature range and excellent contrast in high brightness environment. The main disadvantage is higher power consumption ...

In this article I’m going to show you how an 8x8 LED Dot Matrix Display can be driven by MAX7219 with Arduino.There are 2 similar designs. PIC16F876 version is  available at this link ,for circuit based on 74HC595 click here.For this project ...

Wireless Infrared UART prototype can be built by using two PIC16F876A controllers. One as IR receiver with dedicated Infrared decoder like SFH505A, SFH506 or similar IR receiver IC and other microcontroller as a transmitter via IR LEDs. This is relatively simple ...

This is an upgrade to recently published Simple Digital Voltmeter.Few improvements were done to hardware and software.DVM operating range  was slightly increased up to 24 V Max, however the most significant change is that the code now uses full 10 bit of ...

The topic of this post is building sine wave generator based on Arduino UNO and PCF8591 8-bit A/D and D/A converter. For similar design with PIC micro-controller look at this link. Raspberry Pi version based on MCP4725 DAC available at ...

In this post we’ll review a simple interface for PCF8574 I2C 8-bit IO expander IC and PIC microcontroller. For similar Arduino based implementation click this link. The format of present post is similar to 2 recently published tutorials about I2C ...

In this article I’ll show you how you can use PIC microcontroller to record and store waveform patterns in its EEPROM memory and replay the sequence later. For this purpose we’ll need a signal/waveform generator to produce the signal, PIC ...

In this article we’ll see how to generate 1 Hz clock with PIC16F876/877 PIC microcontrollers. 3 different approaches will be demonstrated. The most basic solution is to use nested loops to “waste” enough instruction cycle time in order to produce ...

Interfacing Humidity and Temperature Sensor DHT11 with Arduino platform is the topic of this post. I’ve published a number of designs with various temperature sensor, both digital and analog. Here you can see how to use LM75A digital sensor with ...