In this post a simple Digital Dual Voltmeter and Ampere meter design will be shown. It uses PIC16F876A microcontroller and 2x16 LCD display and has 2 input channels for measuring voltage in 0-25v range and current up to 500mA. The ...

Arduino clock can be implemented by using LCD Shield Board for Arduino. This shield can simplify the prototyping process of many Arduino based circuits. It incorporates a 16x2 display and a basic 6 buttons keypad thus removing the need for ...

This is PIC16F877A microcontroller based digital clock with 7-Segment display. For this project LTC3710HR was used, however the schematic can be easily adjusted to incorporate larger displays.LTC3710HR is 0.3 inch quadruple digit multiplex common cathode display.Main consideration for choosing the display ...

Basic Stepper Motor Controller can be built with Arduino board and a few additional components like MOSFET switches and a potentiometer to control unipolar stepper motor speed and direction. The principle of operation is relatively simple. When a potentiometer is ...

Here is a modified and improved electronic lock design. For Arduino version click here.It is largely based on Digital Lock article, however this time a real electronic lock was used instead of a solenoid. The code is a 4 digit number ...

Measuring current is a relatively simple task that can be done by connecting a shunt resistor in series with the load and measuring the voltage on this resistor. The voltage is proportional to a load current according to Ohm’s law ...

This post is about building a basic distance meter with ultrasonic HC-SR04 sensor and PIC micro controller. For Arduino version click here. Raspberry Pi variant is also available at this link The interface is very simple and does not require too many commands ...

In this post we’ll add a serial data transfer capability to a standard 7-Segment LED Display by using PCF8574 I/O Port expander IC with I2C interface.For similar design based on Arduino see this link. Usually in order to minimize required ...

Simple digital voltmeter can be built by using PIC microcontroller and a few discrete components. PIC16F877A 10 bit ADC module was used for this purpose, we’ll work only with 8 upper bits to translate input voltage to digital form and ...

When working with multiple 7-Segment displays a multiplexing scheme is required in order to simplify the design and save Raspberry Pi I/O pins. Such implementations shown in this design. As can be seen from a schematic diagram 2 7-Segment displays ...