In this article I’ll show you how you can use PIC microcontroller to record and store waveform patterns in its EEPROM memory and replay the sequence later. For this purpose we’ll need a signal/waveform generator to produce the signal, PIC ...

This is PIC16F877A microcontroller based digital clock with 7-Segment display. For this project LTC3710HR was used, however the schematic can be easily adjusted to incorporate larger displays.LTC3710HR is 0.3 inch quadruple digit multiplex common cathode display.Main consideration for choosing the display ...

8x8 LED Matrix chaser based on Arduino MEGA compatible board will be presented in this post. It uses a LED dot matrix display module with two 74HC595 shift register chips connected in serial to control the LED output. Similar design ...

Raspberry Pi I/O capabilities can be expanded by adding one or cascading a number of shift registers. In this design 74HC595 example is shown. 74HC595 is a very popular and relatively cheap IC. There are assembled modules based on this ...

When working with multiple 7-Segment displays a multiplexing scheme is required in order to simplify the design and save Raspberry Pi I/O pins. Such implementations shown in this design. As can be seen from a schematic diagram 2 7-Segment displays ...

Here is another version of Arduino based voltmeter. This time it uses 4-digit 7-Segment LED display and MAX7219 Display Driver. For similar design with 2x16 LCD display click this link. Also you can look at PIC16F876 implementation in my previous ...

3 Digit Up Down Counter shown here is based on PIC16F877A microcontroller. The count is shown on the 2x16 LCD display and the direction is controlled by a switch connected to bit 3 of PORTA. With minimal changes the attached ...

Arduino clock can be implemented by using LCD Shield Board for Arduino. This shield can simplify the prototyping process of many Arduino based circuits. It incorporates a 16x2 display and a basic 6 buttons keypad thus removing the need for ...

A simple light sensor can be built using a photoresistor and Arduino UNO board. Similar design is available here. This design requires only a few additional components like 10k resistor and a 10k potentiometer to adjust the light intensity level ...

Recently I was asked to build an aquarium lighting controller prototype to provide variable brightness during its operation and ability to program  ON/OFF times. 25 blue and white diffused 10mm LED were used to illuminate the aquarium. The main requirement from ...