pic

This post is about building a simple LED controller circuit. Several articles were published on this subject. Here is just one link to similar design that can be useful. Search the site for more information. Current design  relies on well-known technique to ...

3 Digit Dot Matrix Display with SPI interface is an advanced version of recently published 7x5 Dot Matrix Character Generator project. This design is more complex as it contains 4 microcontrollers. Three PIC16F88 were used to control 7x5 Dot Matrix Displays, ...

9 Volt batteries extensively used in various electronics measurement equipment. Powering these devices with  rechargeable batteries can be a cost effective solution. In this post a simple Lithium-ion 9 Volt Battery Charger design with overcharging protection will be presented. Charger is ...

Power Supply is probably the most common electronics project you can build.This is a basic design for digital power supply. It was built around 3 main components. Digital potentiometer – MCP4251-502E/P, Low  Dropout Voltage Regulator – MIC29152 and PIC16F877A.The idea ...

Recently I was asked to build an aquarium lighting controller prototype to provide variable brightness during its operation and ability to program  ON/OFF times. 25 blue and white diffused 10mm LED were used to illuminate the aquarium. The main requirement from ...

This post is about building a basic distance meter with ultrasonic HC-SR04 sensor and PIC micro controller. For Arduino version click here. Raspberry Pi variant is also available at this link The interface is very simple and does not require too many commands ...

Digitally Controlled Power Supply from 0-14 Volt based on PIC16F876A will be demonstrated in this post. This is a modification of Digital Power Supply 2.5-12V article and has similar characteristics. The most noticeable difference is the use of PCF8591P I2C Digital to ...

Due to popular demand I've modified digital clock design to work with LCD display instead of 7-Segment LED as described in this post. For Arduino version click here. All the capabilities of LED version have been maintained in current project. 1 ...

Pulse Width Modulation (PWM) is very common technique for controlling cooling fan speed in Desktop PC. In this project PIC16F877A based Pulse Width Modulation  controller was built and tested with 2 fans. 80 mm Coolink SWiF2-80P PWM Fan and Arctic Cooling ...

This very simple design shows how to make a blinking LED using PIC16F684 MCU. In my previous post I’ve used PIC16F877/86 however most of basic circuits do not require a lot of I/O pins and PIC16F684 small 14 pin package is more ...