pic

In this post I'll show how you can drive 7 Segment LED display with PIC16F876A. Instead of using a dedicated IC’s like 4511 we’ll program the micro controller to convert  BCD input code 0 – 9 to a 7 Segment LED ...

Following recently published article about building a PWM Fan Controller here is another simple controller design. This time it’s a 2 Channel PC Fan Controller for standard 12V Fans. It uses software implementation of PWM but instead of directly driving PWM ...

In this article I’ll show you how to program Microchip PIC microcontrollers using HI-TECH PICC compiler and basic PIC development board. The board consists of PIC16F876A, LED bar graph and 20MHz oscillator. PICKIT3 compatible programmer was used to download the ...

Here is a modified and improved electronic lock design. For Arduino version click here.It is largely based on Digital Lock article, however this time a real electronic lock was used instead of a solenoid. The code is a 4 digit number ...

This is an upgrade to recently published Simple Digital Voltmeter.Few improvements were done to hardware and software.DVM operating range  was slightly increased up to 24 V Max, however the most significant change is that the code now uses full 10 bit of ...

This post is about building a simple PIC16F88 based DC motor controller. Motor speed and direction can be controlled by two push buttons SW1, SW2. One for motor speed and the other for polarity. This post follows recently published projects like PWM ...

Solar power mobile charger can be built by tweaking digital power supply schematic. The Software/Hardware stayed almost the same as the original circuit.Current design has the same overcurrent protection and output voltage can be changed by pressing SW1. Voltage and Current ...

Digitally Controlled Power Supply from 0-14 Volt based on PIC16F876A will be demonstrated in this post. This is a modification of Digital Power Supply 2.5-12V article and has similar characteristics. The most noticeable difference is the use of PCF8591P I2C Digital to ...

In this post I’m going to show you how to interface an I2C Real Time Clock – RTC with PIC microcontroller. Only a basic hardware configuration and a communication protocol are presented here. I’m planning to extend it to a ...

This post is about building a basic distance meter with ultrasonic HC-SR04 sensor and PIC micro controller. For Arduino version click here. Raspberry Pi variant is also available at this link The interface is very simple and does not require too many commands ...