pic

MAX7219 is a common cathode display driver with a simple serial interfaces that can be easily connected to a microcontroller. Among other useful features this IC has built in brightness control and scan control capability that allows to limit the ...

3 Digit Dot Matrix Display with SPI interface is an advanced version of recently published 7x5 Dot Matrix Character Generator project. This design is more complex as it contains 4 microcontrollers. Three PIC16F88 were used to control 7x5 Dot Matrix Displays, ...

Light emitting diode (LED) Controller was built using PIC microcontroller and LM317 regulator. Comparing to traditional light sources led illumination should provide more efficient lighting also giving you a possibility to choose desired wavelength. 48 white diffused LEDs connected in parallel ...

This article shows how to create a fading/dimming effect of the LED using PIC micro-controller. For similar design based on Arduino click this link.Controlling LED brightness using PWM is a relatively simple task and can be accomplished by configuring PIC16F877 ...

Digitally Controlled Power Supply from 0-14 Volt based on PIC16F876A will be demonstrated in this post. This is a modification of Digital Power Supply 2.5-12V article and has similar characteristics. The most noticeable difference is the use of PCF8591P I2C Digital to ...

In this post we’ll review a simple interface for PCF8574 I2C 8-bit IO expander IC and PIC microcontroller. For similar Arduino based implementation click this link. The format of present post is similar to 2 recently published tutorials about I2C ...

In this post a basic character generator design based on PIC16F88 will be demonstrated. 7x5 Dot Matrix Display was used and its pin out is shown in the schematic below. Instead of using PIC16F876/7 microcontrollers PIC16F88 was chosen for this purpose ...

Interfacing LCD Display with serial Interface like I2C can save microcontroller I/O making it a practical alternative to a standard parallel 8 bit interface. We’ll use PCF8574 I2C port expander and PIC16F876A microcontroller to establish IIC communication by 2 lines, ...

This is an upgrade to recently published Simple Digital Voltmeter.Few improvements were done to hardware and software.DVM operating range  was slightly increased up to 24 V Max, however the most significant change is that the code now uses full 10 bit of ...

Solar power mobile charger can be built by tweaking digital power supply schematic. The Software/Hardware stayed almost the same as the original circuit.Current design has the same overcurrent protection and output voltage can be changed by pressing SW1. Voltage and Current ...