Digitally Controlled Power Supply from 0-14 Volt based on PIC16F876A will be demonstrated in this post. This is a modification of Digital Power Supply 2.5-12V article and has similar characteristics. The most noticeable difference is the use of PCF8591P I2C Digital to ...

Arduino based 3 Digit Timer with LED Display module is a relatively simple design. Recently I’ve published a number of similar projects that essentially perform the same task. You set up an initial value via some kind of user interface ...

In this post a basic character generator design based on PIC16F88 will be demonstrated. 7x5 Dot Matrix Display was used and its pin out is shown in the schematic below. Instead of using PIC16F876/7 microcontrollers PIC16F88 was chosen for this purpose ...

Here is another digital clock design based on Arduino platform. This time it uses 4-Digit LED Dot Matrix module to show the time. Similar design with LCD display is available here. The Dot Matrix module consists of four MAX7219 chips ...

In this article I’ll show you how to program Microchip PIC microcontrollers using HI-TECH PICC compiler and basic PIC development board. The board consists of PIC16F876A, LED bar graph and 20MHz oscillator. PICKIT3 compatible programmer was used to download the ...

Interfacing LCD Display with serial Interface like I2C can save microcontroller I/O making it a practical alternative to a standard parallel 8 bit interface. We’ll use PCF8574 I2C port expander and PIC16F876A microcontroller to establish IIC communication by 2 lines, ...

This post is about building a 3-digit countdown timer based on Arduino MEGA. Up/Down counter also available at this link. The timer will wait for 3-digit number to be entered via 4x3 keypad and then start counting down to zero ...

In this article I’ll show you how you can use PIC microcontroller to record and store waveform patterns in its EEPROM memory and replay the sequence later. For this purpose we’ll need a signal/waveform generator to produce the signal, PIC ...

Relay controlled by light intensity can be implemented using Arduino UNO compatible board. In this case Keyestudio UNO R3 and AD/DA module with PCF8591 chip. Similar simpler design is available here. On this particular module a photoresistor and a potentiometer ...

Following recently published article about building a PWM Fan Controller here is another simple controller design. This time it’s a 2 Channel PC Fan Controller for standard 12V Fans. It uses software implementation of PWM but instead of directly driving PWM ...