Digital Alarm Clock based on Arduino MEGA board and 2x16 LCD display is the topic of this post. Similar design based on Raspberry Pi can be found at this link. For PIC16F877 version click here. This design should also work ...

Wireless Infrared UART prototype can be built by using two PIC16F876A controllers. One as IR receiver with dedicated Infrared decoder like SFH505A, SFH506 or similar IR receiver IC and other microcontroller as a transmitter via IR LEDs. This is relatively simple ...

In this post I'm going to show you how to build a simple Digital Lock using PIC microcontroller. Instead of building a new hardware design from scratch we are going to use PIC Development Board as a basis for Digital ...

Measuring current is a relatively simple task that can be done by connecting a shunt resistor in series with the load and measuring the voltage on this resistor. The voltage is proportional to a load current according to Ohm’s law ...

This post is about building a simple PIC16F88 based DC motor controller. Motor speed and direction can be controlled by two push buttons SW1, SW2. One for motor speed and the other for polarity. This post follows recently published projects like PWM ...

This is an upgrade to recently published Simple Digital Voltmeter.Few improvements were done to hardware and software.DVM operating range  was slightly increased up to 24 V Max, however the most significant change is that the code now uses full 10 bit of ...

Using HC-SR04 Ultrasonic Sensor with Raspberry Pi is a relatively easy task. HC-SR04 is a very popular module that can provide the distance to the object by sending ultrasonic bursts at 40kHz and measuring the time it takes for the ...

Recently I’ve published a basic Binary to Hexadecimal converter design based on Atmega 2560 chip. The same set up can be used for building a simple UP/Down counter with Arduino Mega compatible board. 7-Segment display and its I/O stayed the same ...

This post is about building a simple LED controller circuit. Several articles were published on this subject. Here is just one link to similar design that can be useful. Search the site for more information. Current design  relies on well-known technique to ...

Interfacing a Thermocouple with Arduino platform can be easily done by integrating a MAX31855 to your project. This IC is a Cold-Junction Compensated Analog to Digital Converter amplifier especially design for use with a Thermocouple. The converter provides 14-Bit of ...