pic

Here is another fan controller design based on PIC microcontroller, this time it's temperature controlled and can be used to monitor Hard Drive temperature and adjust the fan speed accordingly or as a case fan controller. This post following recently ...

In this post I'll show a simple running LED circuit. Currently only 2 patterns are available but additional effects can be easily added by slightly modifying the code. This design uses only 16 LED's however PIC16F877 has 5 I/O ports ...

Digitally Controlled Power Supply from 0-14 Volt based on PIC16F876A will be demonstrated in this post. This is a modification of Digital Power Supply 2.5-12V article and has similar characteristics. The most noticeable difference is the use of PCF8591P I2C Digital to ...

In this article I’ll show you how you can use PIC microcontroller to record and store waveform patterns in its EEPROM memory and replay the sequence later. For this purpose we’ll need a signal/waveform generator to produce the signal, PIC ...

Vacuum fluorescent display can be a good alternative to a Liquid-crystal displays in some applications. They have a number of advantages over LCD like extended temperature range and excellent contrast in high brightness environment. The main disadvantage is higher power consumption ...

In this post a basic character generator design based on PIC16F88 will be demonstrated. 7x5 Dot Matrix Display was used and its pin out is shown in the schematic below. Instead of using PIC16F876/7 microcontrollers PIC16F88 was chosen for this purpose ...

Solar power mobile charger can be built by tweaking digital power supply schematic. The Software/Hardware stayed almost the same as the original circuit.Current design has the same overcurrent protection and output voltage can be changed by pressing SW1. Voltage and Current ...

Due to popular demand I've modified digital clock design to work with LCD display instead of 7-Segment LED as described in this post. For Arduino version click here. All the capabilities of LED version have been maintained in current project. 1 ...

This article shows a basic interface between PIC16F microcontroller and a unipolar stepping motor using an assembly code. For programming the MCU you'll need PICKIT2 or PICKIT3 device. Similar design for Arduino platform can be  found at this link. Instead ...

In this post a simple Digital Dual Voltmeter and Ampere meter design will be shown. It uses PIC16F876A microcontroller and 2x16 LCD display and has 2 input channels for measuring voltage in 0-25v range and current up to 500mA. The ...